Bellevue · Viking
Range Repair
Sealed-burner ignition, simmer control and dual-fuel oven faults on Viking professional ranges.
Symptoms
What people describe when they call about this.
- 01 Burner clicks over and over but never lights
- 02 Flame is orange and lifting off the burner cap
- 03 Simmer setting goes out whenever the hood fan is on
- 04 Griddle plate heats on one half and stays cold on the other
What it costs
The number arrives before the toolbag does.
Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.
Each line below is a range because the fault decides where inside it you land — a thermostat that only needs recalibrating sits at the bottom, a sealed system opened up and recharged sits at the top. Whichever it turns out to be, you are given one figure covering parts and labour and you agree it before work starts. Nothing is dismantled until you have said yes, and the $89 you paid for the visit comes off that figure the moment you approve the repair.
- Igniter or burner assembly $170 to $450
- Oven thermostat or heating element $200 to $430
- Refrigeration fan or defrost system $280 to $670
- Dishwasher pump or control $200 to $380
- Control board or touch panel $420 to $640
- Compressor or sealed-system repair $1,400 to $3,210
For scale, the alternative — a comparable Viking replacement, before installation — runs $7,060–$16,540 today. That is the figure the ranges above are measured against, and on the day we will say so plainly if yours has become the appliance that is no longer worth repairing.
How the visit runs
Three stages, no surprises in between.
- Step 1
We ask before we drive
Model number, what changed, and when. Half of Viking range repair calls are narrowed to two or three candidates on the phone.
- Step 2
We measure on site
Readings, not guesses — and we show you the meter. If the fault is not what you were told it was, you will hear that too.
- Step 3
You approve a number
Parts and labour on one line, written down before anything is dismantled. The figure you agree to is the figure on the invoice.
Also on the van
The rest of the Viking kitchen.
- Refrigerator Repair Built-in and panel-ready Viking refrigeration: cooling loss, defrost faults and door-seal problems.
- Oven Repair Convection, bake-element and thermostat calibration work on Viking wall ovens and range ovens.
- Dishwasher Repair Drain, wash-arm, heat and leak diagnostics for Viking integrated and panel-front dishwashers.
In their words
Range Repair calls that went the way they should have.
Three Bellevue jobs on this side of the Viking kitchen — the symptom, the fault, the fix.
4.9 / 51,579 reviews
Griddle heated on the left half and stayed stone cold on the right. One dead element leg, not the whole griddle assembly I had been told to replace.
Rasheed K.Bridle Trails
Orange lifting flames on three burners after a remodel. He found the orifices still set for propane and swapped them back for natural gas. Sorted properly. Four stars only because the parts wait ran two days.
Thora T.Bridle Trails
The rangetop worked but the oven under it would not light. Not the igniter — a safety valve that had stopped opening. He showed me the resistance reading first.
Otto P.Somerset
Next step
Describe the fault and we will tell you what it usually is.
Range Repair in Bellevue — most faults are closed on the first visit from van stock.
Vans out 8:00 am – 8:00 pm, seven days. The line is answered 24/7.
